Page 105 - MCCB-XT2-XT4
P. 105

ABB | SACE Tmax XT

                       Parameters 2 The Datalogger 1 and Datalogger 2 submenus (available if the number of dataloggers selected is: 2)
                                    contain the following options:
                                     Parameter    Description                                         Default
                                                  Trigger event at which the recording is to be interrupted; the
                                                  main protection options (trips, timings, alarms) and the actuator
                                     Stop Event                                                       None
                                                  status (open/closed) are displayed.
                                                  The Custom option can be configured via Ekip Connect
                                                  Recording interruption delay, calculated from the trigger; the
                                     Stop delay   value is given in seconds and can be set within a range: 0 s to 10   0.01 s
                                                  s, in 0.01 s steps
                                     Restart      Recording start command
                                     Stop         Manual recording stop command

                                    Memory Type
                                    Ekip Connect enables the Memory Type (Non volatile/Volatile) to be selected:
                                     •  Non volatile: Ekip Touch maintains the registration even when off; the life of the internal battery
                                       of the unit can be sensibly less than the declared value in the absence of auxiliary power supply.
                                     •  Volatile: Ekip Touch loses the recording if it is switched off; when the unit is switched on again,
                                       the datalogger automatically restarts, losing the previously stored data.
                                    The parameter is configured by default as Non volatile.


                         Signallings If there is a recording present, Ekip Touch provides the information on the diagnosis bar (DLog1 available).
                                           NOTE: In the configuration with two dataloggers, the specific indication of the available
                                           recording is shown (DLog1 available or DLog2 available)



                       Ekip Connect Ekip Connect 3 has two specific areas for the Datalogger function:
                                     •  Datalogger for configuring the recording parameters with a user-friendly interface, and for
                                       downloading the recordings
                                     •  Data Viewer for opening and consulting the recordings
                                    Both areas are available in the Tools menu of Ekip Connect and are described in the Help section of the
                                    application.












































       103 | © 2022 ABB |  1SDH002031A1002 - ECN000212994                         Ekip Touch - Measurements | 4 - Datalogger
   100   101   102   103   104   105   106   107   108   109   110