Page 4 - Assembly Instructions Manual
P. 4
- Place all the Corners on the assembly table with
the outer 8mm thread facing the tabletop.
- Put the corner bars for the top and bottom frames
on the assembly table and turn them with the flat
surface of the cross anchor points facing down-
wards.
- Fix the Corners to panel depth Corner Bars
- Make sure that the surfaces described in fig.7
are correct after assembling.
- Fix depth Corner Bar assembly to the
panel length Corner Bars.
- This is how the top and bottom frames must look.
02 ISSUED BY: F. P DATE: 01.10.2007 APPROVED BY: A. K DATE: 01.10.2007 REPLACES: 01.04.2005
