Page 24 - ACB-E1.2-E2.2-E4.2-E6.2

ABB | SACE Emax 2

Settings Menu Menu Submenus Description and parameters
Enable (5) Enabling and configuration of Bluetooth
Bluetooth Low Energy Low Energy communication:
- See the manual 1SDH001330R1001
Configuration Phase number selection
Hardware Trip Protection activation command
T Protection Protection activation command
Circuit Breaker
Neutral Protection (2) Enable, Neutral threshold
Earth protection (7) External toroid configuration
Installation Installation of modules
Main Frequency - Grid frequency configuration
Phase Sequence - Phase sequence configuration
Local/Remote Parameter writing configuration
Local Bus Configuration of local bus presence
Modules
Modul x (3) Details in chapters of each module
Functions Switch On LOCAL, Signalling RESET
Monitor time - Measuring range configuration
Test Bus - Test bus activation
Enable (5) Function enabling and parameters: see
details in dedicated chapter
Power Controller (4)
- Function enabling and parameters: see
manual 1SDH001330R1002
Enable (5) Function enabling and parameters: see
details in dedicated chapter
Load Shedding (4)
- Function enabling and parameters: see
manual 1SDH001330R1002
Enable (5) Function enabling and parameters: see
details in dedicated chapter
Network Analyzer (6)
- Function enabling and parameters: see
manual 1SDH001330R1002
Enable (5) Function enabling and parameters: see
details in dedicated chapter
Datalogger (6)
- Function enabling and parameters: see
manual 1SDH001330R1002
Enable (5) Function enabling and parameters: see
details in dedicated chapter
Dual Set (6)
Default set Function enabling and parameters: see
manual 1SDH001330R1002
Date Configuration of unit date
Time Configuration of unit time
System
Language Configuration of menu language
New PIN PIN Configuration
Representation parameters of menus and
measurements: see details in dedicated
View - chapter
Function enabling and parameters: see
manual 1SDH001330R1002
YO Command
Functions Function, Delay
YC Command
Maintenance Alarms Activation of maintenance signals
Motor protection parameters: see details in
MLRIU (8) -
dedicated chapter
(1) with CB in 3P configuration
(2) available with CB in 4P or 3P with neutral configuration
(3) the menu populates with the list of accessory modules detected by the unit with Local Bus
activated and in the envisaged connection and supply conditions
(4) available if the function has been installed in the Trip unit
(5) additions are only made to the list of the specific submenu when the function is enabled (=On)
(6) available if provided for by Trip unit model or if relative SW package has been activated
(7) available with LSIG versions

22 | © 2022 ABB | 1SDH001316R1002 - ECN000232533 Ekip Touch - Interface and menus | 4 - Menu