Page 46 - ACB-E1.2-E2.2-E4.2-E6.2

P. 46

ABB | SACE Emax 2

Bluetooth Low Energy - The following parameters are available
Parameters
Parameter Description Default
Enables/disables Bluetooth Low Energy antenna switch-on and
availability of the other parameters in the menu:
Enable • if On, the antenna comes on, on the basis of the Battery Mode Off
parameter configuration
• if Off, the antenna is off
Defines the switch-on mode of the Bluetooth Low Energy antenna,
based on the presence of the devices on the service connector (Ekip
T&P, Ekip Programming, Ekip TT); can have two values:
• --- ; with this option, the state of the antenna depends esclusively on
the presence of devices: on if not present; off if present
• ON ; with this option, the antenna is switched off for 15
Battery mode seconds when a device is connected, after which: it remains off if ---
communication with the device has been activated; it comes on if no
communication has been activated
IMPORTANT: the typical scenario in which Battery mode should
be configured = On is: Ekip Touch + Ekip TT + communication
with smartphone activated; in all other cases, including System
Update, configure Battery mode = ---
Command which starts Pairing between Trip unit and external device.
To perform the operation correctly:
1. Press Connect on EPiC APP, select the Trip Unit from among the units
in the list and then select Connect again
2. Press Start Pairing in the Trip unit menu, enter the PIN, then press
Start Pairing again
3. Press Start Pairing on EPiC APP and confirm the operations until the
code request appears
Start Pairing 4. Check that the pop up with the Passkey appears on the display of the ---
Trip unit (about 20 seconds) and enter it in EPiC APP
5. The Trip unit will be connected to the external device from this
moment on; for the successive re-connections, it will be sufficient to
just repeat point 1
NOTES:
• execute the procedure within 120 seconds
• the command is not available if communication with a device is
activated
Command that deletes the list of devices coupled to the Trip unit
Decouple NOTE: the command is not available if communication with a ---
devices
device is activated
Version FW version of the Bluetooth Low Energy module installed on board ---

IMPORTANT: when Bluetooth Low Energy antenna is on, communication on the service
connector is not available

Test Bus The parameter allows parameter editing via the service connector to be enabled/disabled, thereby
limiting the possibility of configuring all the options on the display (in the Local mode) or via modules
Ekip Com (in the Remote mode).
Disabling the parameter, Local mode and using the PIN allow security against undesired modification by
unauthorized persons to be increased.
NOTE: with Test Bus= Off, communication via service connector is still guaranteed (reading
enabled)
Ekip Touch is supplied with the parameter set to: On.

System The System menu provides various options:
Parameter Description Default
Date Setting the current date
Time Setting the current time
Language Setting the language in display menus English
PIN PIN setting (page 26) 00001

IMPORTANT: setting and checking Date and Time is important for all the recording
functions (trips or measurements); in the event of date and time glitches, reset and if
necessary replace the battery inside Ekip Touch (page 51).

41 42 43 44 45 46 47 48 49 50 51