Page 48 - Sace Emax 2 Manual for design engineers

ABB | SACE Emax 2
Settings Menu Menu Submenus Description and parameters Page
Enable (5) Enabling and configuration of Bluetooth
Bluetooth Low Energy 128
- Low Energy communication
Configuration Phase number selection 127
Hardware Trip Protection activation command
T Protection Protection activation command 61
Circuit Breaker
Neutral Protection (2) Enable, Neutral threshold
Earth protection (7) External sensor configuration 129
Installation Installation of modules 47
Main Frequency - Grid frequency configuration 127
Phase Sequence - Phase sequence configuration 64
Local/Remote Parameter writing configuration
Local Bus Configuration of local bus presence
Modules 128
Modul x (3) Details in chapters of each module
Functions Switch On LOCAL, Signalling RESET
Monitor time - Measuring range configuration 112
Test Bus - Test bus activation 130
Enable (5) Function enabling and parameters: see
Power Controller (4) 139
- details in dedicated chapter
Enable (5) Function enabling and parameters: see
Load Shedding (4) 139
- details in dedicated chapter
Enable (5) Function enabling and parameters: see
Network Analyzer (6) 120
- details in dedicated chapter
Enable (5) Function enabling and parameters: see
Datalogger (6) 118
- details in dedicated chapter
Enable (5) Function enabling and parameters: see
Dual Set (6) 79
Default set details in dedicated chapter
Date Configuration of unit date
Time Configuration of unit time
System 130
Language Configuration of menu language
New PIN PIN Configuration
Representation parameters of menus
and measurements: see details in
View - 130
dedicated chapter
YO Command
Functions Function, Delay 89
YC Command
Maintenance Alarms Activation of maintenance signals 113

(1) with CB in 3P configuration
(2) available with CB in 4P or 3P with neutral configuration
(3) the menu populates with the list of accessory modules detected by the unit with Local Bus activated and in
the envisaged connection and supply conditions
(4) available if the function has been installed in the Trip unit
(5) additions are only made to the list of the specific submenu when the function is enabled (=On)
(6) available if provided for by Trip unit model or if relative SW package has been activated
(7) available with LSIG versions

46 | © 2020 ABB | 1SDH001330R1002 - ECN000134959 - Rev. A Ekip Touch - Interface and menus | 4 - Menu