Page 25 - MCCB-XT2-XT4

ABB | SACE Tmax XT

LEDs LEDs Colour Description
Indicates the on status of Ekip Touch:
• off: no power and unit off
• on, steady (Power mode) or flashing (Alive mode): unit on and self-supplied
Power by external Vaux or service connector
Green The Power mode or Alive mode can be selected via Ekip Connect: if the Alive
mode has been selected and external modules are connected, the Power leds
of Ekip Touch and the modules flash in the synchronized mode.
More details are given in the chapter on Ekip Connect additional functions on
page 117
Warnings Signals that certain alarms are present:
Yellow • off: no alarm
• on steady: prealarm of an active protection or status contacts error
Signals that an alarm is present:
Alarm • off: no alarm
Red • on steady: on steady signals a TRIP due to a protection
• on flashing: protection timing tripped or alarm due to disconnection of a
current sensor

If on and flashing at the same time, the Warning and Alarm leds signal an alarm caused by a hardware
error inside the Trip unit.
This case requires assistance from ABB.

Push-buttons Push-button Description
Allows certain pages of information about the unit to be consulted rapidly.
Press the button in succession to display the following pages:
• Alarm list: when alarms are present
• Protection unit: with information about the Trip unit
• Circuit-breaker: with information about the CB
iTest • Last trip: with information about the last protection trip performed by the Trip
unit, if available
Rapid consultation using the iTEST button is active from the measuring page
NOTE: with the Trip unit off and the internal battery charged, press iTEST to
temporarily switch on the Power led and, only in the case of a TRIP, the display
with information about the protection that caused the trip and the Alarm led
Allows the user to:
• view the main menu when the Trip unit displays the measuring pages
ESC
• view the measuring menu when the Trip unit displays the main menu
• go back to the upper level when navigating among the submenus
Allows the user to:
• view the main menu when the Trip unit displays the measuring pages
• select the required submenu
Enter
• confirm entry of the password required when the Trip unit parameters must be
edited
• confirm or annul the changes made to the Trip Unit parameters
Allows the user to:
• scroll the measuring pages
• move to the right when navigating the main menu
Right/Up
• move up when navigating the submenus
• change the individual numeric characters of the password, increasing them by 1
whenever the button is pressed
Allows the user to:
• scroll the measuring pages
• move to the left when navigating the main menu
Left/Down
• move down when navigating the submenus
• change the individual numeric characters of the password, decreasing them by 1
whenever the button is pressed

Service connector The service connector enables Ekip Touch to be connected to Ekip TT, Ekip T&P and Ekip Programming,
allowing the unit to be temporarily supplied, parameter configuration prior to putting into service, tests
and extension of the configuration functions.
IMPORTANT: only use cables supplied by ABB or with ABB accessories

23 | © 2022 ABB | 1SDH002031A1002 - ECN000212994 Ekip Touch - Interface and menus | 1 - Presentation of interface