Page 26 - MCCB-XT2-XT4

ABB | SACE Tmax XT

2 - Graphic pages

Main page This is the page that appears when the Trip unit is powered up.
The page is divided into three main sections

Figure 9

Pos. Description
A Maximum phase current measured in real time
B Diagnosis bar
Info icons:
Auxiliary supply present, Ekip Com modules connected and remote
parameter writing configuration active
Auxiliary supply present;
C
Trip unit supplied by service connector
The letter corresponding to the active configuration is displayed if the Dual
or Set function is enabled; further details on page 62

Summary page Further measurement pages can be displayed by using the Right/Up and Left/Down buttons at the side
of the display (1).

Figure 10
The list of additional measurement pages available depends on whether Neutral voltage is present or not
(always present in the case of four-pole Trip units, to be configured in the case of 3P+N Trip units).
The following additional pages are available if the Trip unit is configured without Neutral voltage:
• maximum measurements page: instantaneous maximum phase current, maximum line-to-line
voltage, cos Ø phase difference measured
• current measurements page: instantaneous phase current
• voltage measurements page: instantaneous line-to-line voltages
• active power measurements page: instantaneous phase active power measurements
• reactive power measurements page: instantaneous phase reactive power measurements
• total power measurements page: instantaneous phase total power measurements
• energy metering page: total active, reactive and apparent energy metering

Continued on the next page

24 | © 2022 ABB | 1SDH002031A1002 - ECN000212994 Ekip Touch - Interface and menus | 2 - Graphic pages