Page 168 - MCCB-XT5

ABB | SACE Tmax XT

Output parameters All the available inputs enable the following parameters to be configured:
Parameter Description Default
Event which activates the output and switches the contacts.
Different protection proposals, statuses and thresholds are
Signal source available on the display; the Custom mode can be configured None
via Ekip Connect so as to extend the solutions and combine
several events
Minimum duration of the presence of the source before the
output is activated; the delay is given in seconds and can be
set within range: 0 s to 100 s, in 0.01 s steps
NOTES:
Delay 0 s
• the output will not be switched if the source is
deactivated before this time has elapsed
• if delay = 0 s the source must still be present for
longer than 300 µS
Defines the rest status of the contact with source not
Contact Type NO
present between: open (NO) and closed (NC)
Allows the output (and relative status led) to be kept
Latched activated (On) or deactivated (Off) when the event OFF
disappears
Defines the minimum closing time of the contact following
the rapid presence of sources:
• Source duration < min. activation = contact is activated for
min Activation Time the minimum activation time 0 ms
• Source duration ≥ min. activation = contact is activated for
as long as the source persists
Choose between: 0 ms, 100 ms, 200 ms

About The specific menu of the module available in the About - Modules menu contains:
• the serial number and version of the module
• the statuses of the inputs (On/Off) and outputs (Open/Closed)

Test The test area in the Test menu is activated if the Ekip Signalling 2K module is detected correctly.
For details of the test characteristics, please consult page 125.

Remote information Certain additional information concerning the version and status of the module is available via the service
connector (via Ekip Connect) or by communication via system bus; the information includes: HW and Boot
version, CRC status (correctness of the SW in the module).

166 | © 2022 ABB | 1SDH002039A1002 - ECN000212994 External electronic accessories | 13 - Ekip Signalling 2K