Page 208 - MCCB-XT5
P. 208

ABB | SACE Tmax XT

       3 - Ekip Multimeter



                                    Ekip Multimeter is a remote display panel-front module with touchscreen display allowing the parameters
                                    of the Trip unit to which it is connected via local bus to be displayed and edited.
                                    Up to four Ekip Multimeter modules can be connected to the same Trip unit. On the other hand, the
                                    module can only be connected to one Trip unit.
                                    The rear connector allows the unit to be supplied in two different ways:
                                     Terminals / supply
                                     voltage            Frequency           Power input        Inrush current
                                     21,5 ÷ 53 VDC      -                   Maximum 10W        Maximum 2 A for 20 ms
                                     105 ÷ 265 VAC/DC   45 ÷ 66 Hz          Maximum 10 VA/W    Maximum 2 A for 20 ms

                                           IMPORTANT: AC and DC supplies cannot be present at the same time

                                    The module provides for 24 VDC auxiliary voltage (terminals 24 Vout L+ and L-), which can be used to
                                    directly supply the Trip unit.
                                           WARNING! Ekip Multimeter is sized to supply the Trip unit alone, without additional
                                           modules: if auxiliary voltage is used via module, it must be connected directly to the
                                           terminal box of the CB without the possibility of using Ekip Supply or other modules
                                    Connections
                                    Belden 3105A cables or equivalent, up to 15 m in length, must be used for the local bus and auxiliary
                                    supply. The cable shield must be earthed on both sides of the connection.
                                    Documents
                                    Further details are available in ABB Library, especially in document 1SdH001000r0520.


       4 - External neutral



                                    This is a current sensor for the external neutral pole of the circuit-breaker, designed for 3P CBs. It provides
                                    neutral protection via the connection to the Trip unit.
                                    The sensor is available in two versions: one version allows solely the sensor to be connected to the trip
                                    unit; the other version has a connection for neutral voltage (V0).
                                    To configure the presence of the sensor and protection, please consult pages 35 and 49.
                                    Further details about the External neutral connection are available in ABB Library, especially in document
                                    1SdH001000r0506.




































       206 | © 2022 ABB |  1SDH002039A1002 - ECN000212994                     Other electronic accessories | 4 - External neutral
   203   204   205   206   207   208   209   210   211