Page 207 - MCCB-XT5
P. 207

ABB | SACE Tmax XT
        Other electronic accessories




       1 - Ekip Signalling 10K



                                    Ekip Signalling 10K is an external accessory signaling module. It can be installed on a standard 35 mm DIN
                                    rail (DIN EN 50022 type TS 35x15 mm).
                                    This module has:
                                     •  Ten programmable output contacts
                                     •  Ten or eleven programmable digital inputs
                                     •  One power led and twenty or twenty-one signaling leds (one for each input/output)
                                    The module can be set in four different configurations
                                     •  One in case of connection to a Link bus network
                                     •  Three configurations in case of connection via Local Bus (to allow up to three modules to be
                                       connected to the same trip unit)
                                    The module can be supplied by 110...240 V AC / DC or 24...48 V DC.
                                    Further details about  Ekip Signalling 10K are available in ABB Library, especially in document
                                    1SdH001318r0002.
                                           IMPORTANT: make sure that you have read the recommendations concerning safety and
                                           prevention of unauthorized access.


       2 - Ekip Signalling Modbus TCP



                                    Ekip Signalling Modbus TCP is an external accessory module. It can be installed on a standard 35 mm DIN
                                    rail (DIN EN 50022 type TS 35 x 15 mm).
                                    Its function is to share on another Ethernet network with communication protocol.
                                    The module has 11 digital inputs and 10 output contacts:
                                     •  The inputs allow the state of the devices and other information to be monitored
                                     •  The outputs allow the circuit-breakers to be operated.
                                    Each input and output is associated with a state LED.
                                    The module can operate in three modes:
                                     Mode               Characteristics
                                                        The module can be associated with a single circuit-breaker, which can be
                                     CB Supervisor
                                                        selected from a list. Configuration of the inputs and output is pre-defined
                                                        The module can be associated with up to five circuit-breakers.
                                                        Configuration of the inputs and output is pre-defined.
                                     Multi MCCB Supervisor
                                                            NOTE:mode available with moulded-case circuit-breakers

                                     Free I/O           The inputs and outputs can be fully configured by the user

                                    The module can be supplied by 110...240 V AC / DC or 24...48 V DC.
                                    Further details about Ekip Signalling Modbus TCP are available in ABB Library, especially in document
                                    1SdH001456r0002.






















       205 | © 2022 ABB |  1SDH002039A1002 - ECN000212994            Other electronic accessories | 2 - Ekip Signalling Modbus TCP
   202   203   204   205   206   207   208   209   210   211