Page 114 - MCCB-XT2-XT4

ABB | SACE Tmax XT

Bluetooth Low Energy - The following parameters are available
Parameters
Parameter Description Default
Enables/disables Bluetooth Low Energy antenna switch-on
and availability of the other parameters in the menu:
Enable • if On, the antenna comes on, on the basis of the Battery Off
Mode parameter configuration
• if Off, the antenna is off
Defines the switch-on mode of the Bluetooth Low Energy
antenna, based on the presence of the devices on the service
connector (Ekip T&P, Ekip Programming, Ekip TT); can have
two values:
• --- ; with this option, the state of the antenna depends
esclusively on the presence of devices: on if not present; off
if present
• ON ; with this option, the antenna is switched off for 15
Battery mode ---
seconds when a device is connected, after which: it remains
off if communication with the device has been activated; it
comes on if no communication has been activated
IMPORTANT: the typical scenario in which Battery
mode should be configured = On is: Ekip Touch + Ekip
TT + communication with smartphone activated; in all
other cases, including System Update, configure
Battery mode = ---
Command which starts Pairing between Trip unit and
external device. To perform the operation correctly:
1. Press Connect on EPiC APP, select the Trip Unit from
among the units in the list and then select Connect again
2. Press Start Pairing in the Trip unit menu, enter the PIN,
then press Start Pairing again
3. Press Start Pairing on EPiC APP and confirm the operations
until the code request appears
4. Check that the pop up with the Passkey appears on the
Start Pairing ---
display of the Trip unit (about 20 seconds) and enter it in
EPiC APP
5. The Trip unit will be connected to the external device from
this moment on; for the successive re-connections, it will be
sufficient to just repeat point 1
NOTES:
• execute the procedure within 120 seconds
• the command is not available if communication with a
device is activated
Command that deletes the list of devices coupled to the Trip
unit
Decouple devices ---
NOTE: the command is not available if communication
with a device is activated
FW version of the Bluetooth Low Energy module installed on
Version ---
board

IMPORTANT: when Bluetooth Low Energy antenna is on, communication on the service
connector is not available

IMPORTANT: if Bluetooth is disabled during the order (with the extracode) or disabled
by a Service L3 authorized person, the dedicated menu will neither be present, nor visible
nor usable. The icons will not be shown on the screen if Bluetooth is disabled

112 | © 2022 ABB | 1SDH002031A1002 - ECN000212994 Ekip Touch - Settings | 1 - Main settings