Page 116 - 35_DS702_E_2014_Lightning_Protection_Guide
P. 116
DEHNsnap
conductor holder
cap
basic component
DEHNgrip
conductor holder
Figure 5.4.2.2 DEHNsnap and DEHNgrip conductor holders
The DEHNhold conductor holder is made of solid stainless steel ¨ SPANNsnap roof conductor holder with DEHNsnap plastic
(V4A) and can be used for different materials such as Al, StSt conductor holder or DEHNgrip stainless steel (V4A) conduc-
(V4A), St/tZn and Cu. tor holder (Figure 5.4.3.2). A stainless steel (V4A) tension
The DEHNsnap range of plastic holders (Figure 5.4.2.2) is a spring ensures permanent tension. Universal tensioning
basic component (roof and wall). The cap simply snaps in and range from 180 to 280 mm with laterally adjustable con-
fixes the conductor in the holder, ensuring loose conductor ductor routing for 8 mm round conductors.
routing. The special snap-in mechanism does not mechanically ¨ FIRSTsnap conductor holder with DEHNsnap plastic con-
stress the fastener. ductor holder to be fixed on existing ridge tile clips of dry
DEHNgrip (Figure 5.4.2.2) is a screwless stainless steel (V4A) ridges (Figure 5.4.3.3).
holder system. This system can be used as a roof and wall con- The FIRSTsnap conductor holder is snapped on the ridge tile
ductor holder for conductors with a diameter of 8 mm. The clip of dry ridges and tightened by hand (only turn DEHNsnap).
conductor is simply pressed in to fix it in the DEHNgrip (Figure
5.4.2.2). Interlocking tiles, smooth tiles
UNIsnap roof conductor holders with pre-punched braces are
used for roof surfaces. The conductor holder is bent by hand
5.4.3 Instructions for mounting roof conductor before it is hooked into the pantile (Figure 5.4.3.4).
holders
Slated roofs
Ridge and hip tiles When used on slated roofs, the inner hook is bent (Figure
The roof conductor holders are adjusted by means of a locking 5.4.3.5) or provided with an additional clamping part (Part
screw to suit the dimensions of the ridge tile (Figure 5.4.3.1). No. 204 089).
In addition, conductor holders allow to gradually adjust the Interlocking tiles
conductor routing from the top centre to the lower side (con- ¨ FLEXIsnap roof conductor holders for interlocking tiles are
ductor holder can be loosened by either turning the holder or directly pressed on the seams (Figure 5.4.3.6). The flexible
unscrewing the locking screw). stainless steel (V4A) brace is pushed between the interlock-
www.dehn-international.com LIGHTNING PROTECTION GUIDE 115