Page 552 - Din prodcuts 2020

5/108 ELECTRICAL INSTALL ATION SOLUTIONS FOR BUILDINGS 2CHC 420 001 C0201

—
Protection and safety
Data & signal protection
OVR D Series

5
Combined Category D, C, B tested protector (to BS EN 61643) suitable for most
twisted pair signalling applications. Available for working voltages of up to 6,
15, 30, 50 and 110 Volts. For use at boundaries up to LPZ 0 to protect against
flashover (typically the service entrance location) through to LPZ 3 to protect
sensitive electronic equipment.

Features & benefits
• Very low let-through voltage (enhanced protection to • Built-in DIN rail foot for simple clip-on mounting to top
IEC/BS EN 62305) between all lines - Full Mode protection hat DIN rails
• Full Mode design capable of handling partial lightning • Colour coded terminals give a quick and easy installation
currents as well as allowing continual operation of check - grey for the dirty (line) end and green for the clean
protected equipment end
• Repeated protection in lightning intense environments • Screen terminal enables easy connection of cable screen
• Low in-line resistance minimizes unnecessary reductions to earth
in signal strength • Substantial earth stud to enable effective earthing
• Strong, flame retardant, ABS housing • Integral earthing plate for enhanced connection to earth
• Supplied ready for flat mounting on base or side via a OVR CME kit

Application Installation
Use on twisted pair lines, e.g. those found in process Connect in series with the data communication or signal line
control equipment, modems and computer either near where it enters or leaves the building or close to
communications interfaces. the equipment being protected (e.g. within its control
panel). Either way, it must be very close to the system’s
earth star point. Install protectors either within an existing
cabinet/cubicle or in a separate enclosure.

Accessories
Combined Mounting/Earthing kits: Weatherproof enclosures:
OVR CME 4 Mount & earth OVR WBX 4, OVR WBX 4/GS Install in series (in-line)
up to 4 protectors For use with a OVR CME 4
OVR CME 8 Mount & earth and up to 4 protectors DIRTY CLEAN
up to 8 protectors OVR WBX 8, OVR WBX 8/GS
OVR CME 16 Mount & earth For use with a OVR CME 8
up to 16 protectors and up to 8 protectors
OVR CME 32 Mount & earth OVR WBX 16/2/G From line To
up to 32 protectors For use with one or two OVR CME
16 and up to 32 protectors equipment
Earth

Slim Line (OVR SL) and ATEX (OVR SLX) versions are also available. If your system requires a protector with a very low resistance or higher current, see the
OVR E & H Series. Also use the OVR E Series for systems needing a higher bandwidth. Protectors for 3-wire (OVR SL/3W) and RTD (OVR RTD, OVR SL RTD) are
available, as are the space saving protectors (OVR Q, OVR SL Series). The OVR KT and TN Series are additional protectors specifically for telephone lines.