Page 132 - Sace Emax 2 Manual for design engineers

ABB | SACE Emax 2
Test Bus The parameter allows parameter editing via the service connector to be enabled/disabled, thereby limiting
the possibility of configuring all the options on the display (in the Local mode) or via modules Ekip Com (in
the Remote mode).
Disabling the parameter, Local mode and using the password allow security against undesired modification
by unauthorized persons to be increased.
NOTE: with Test Bus= Off, communication via service connector is still guaranteed (reading
enabled)
Ekip Touch is supplied with the parameter set to: On.

System The System menu provides various options:
Parameter Description Default
Date Setting the current date
Time Setting the current time
Language Setting the language in display menus English
Password Password setting (page 50) 00001

IMPORTANT: setting and checking Date and Time is important for all the recording
functions (trips or measurements); in the event of date and time glitches, reset
and if necessary replace the battery inside Ekip Touch (page 256).

View The View menu provides various options:

Parameter Description Default
Enables the orientation of the Alarms List, Measuring Instruments and
TFT orientation Main Measurements pages to be set. The options are: Horizontal, Vertical Horizontal
clockwise, Vertical counter-clockwise
Allows you to activate a supplementary information page, which can
be accessed by pressing the iTEST button twice from any page with a
Customer page Off
diagnosis bar. The information on the new page can be configured via Ekip
Connect (page 132)
Allows the current to be displayed in the Measuring instruments page to be
Ammeter Phase set from among the following options: Imax, I1, I2, I3, Ne (only in the 4P or Imax
3P + N configuration)
Allows the voltage to be displayed in the Measuring instruments page to be
Voltmeter Phase Vmax
set from among the following options: Vmax, V12, V23, V31

Maintenance The parameter allows an alarm, concerning maintenance of the unit, to be enabled/disabled. (page 113).
Ekip Touch is supplied with the parameter set to: On.

130 | © 2020 ABB | 1SDH001330R1002 - ECN000134959 - Rev. A Ekip Touch - Settings | 1 - Main settings