Page 130 - Sace Emax 2 Manual for design engineers

ABB | SACE Emax 2
Bluetooth Low Energy - The following parameters are available
Parameters
Parameter Description Default
Enables/disables Bluetooth Low Energy antenna switch-on and availability of
the other parameters in the menu:
Enable • if On, the antenna comes on, on the basis of the Battery Mode parameter Off
configuration
• if Off, the antenna is off
Defines the switch-on mode of the Bluetooth Low Energy antenna, based
on the presence of the devices on the service connector (Ekip T&P, Ekip
Programming, Ekip TT); can have two values:
• --- ; with this option, the state of the antenna depends esclusively on the
presence of devices: on if not present; off if present
• ON ; with this option, the antenna is switched off for 15 seconds when
Battery mode a device is connected, after which: it remains off if communication with ---
the device has been activated; it comes on if no communication has been
activated
IMPORTANT: the typical scenario in which Battery mode should
be configured = On is: Ekip Touch + Ekip TT + communication
with smartphone activated; in all other cases, including System
Update, configure Battery mode = ---
Command which starts Pairing between Trip unit and external device. To
perform the operation correctly:
1. Press Connect on EPiC APP, select the Trip Unit from among the units in
the list and then select Connect again
2. Press Start Pairing in the Trip unit menu, enter the PIN, then press Start
Pairing again
3. Press Start Pairing on EPiC APP and confirm the operations until the code
request appears
Start Pairing ---
4. Check that the pop up with the Passkey appears on the display of the Trip
unit (about 20 seconds) and enter it in EPiC APP
5. The Trip unit will be connected to the external device from this moment on;
for the successive re-connections, it will be sufficient to just repeat point 1
NOTES:
• execute the procedure within 120 seconds
• the command is not available if communication with a device is
activated
Command that deletes the list of devices coupled to the Trip unit
Decouple NOTE: the command is not available if communication with a device is ---
devices
activated
Version FW version of the Bluetooth Low Energy module installed on board ---

IMPORTANT: when Bluetooth Low Energy antenna is on, communication on the
service connector is not available
IMPORTANT: if Bluetooth is disabled during the order (with the extracode) or disabled
by a Service L3 authorized person, the dedicated menu will neither be present,
nor visible nor usable. The icons will not be shown on the screen if Bluetooth is
disabled

128 | © 2020 ABB | 1SDH001330R1002 - ECN000134959 - Rev. A Ekip Touch - Settings | 1 - Main settings