Page 189 - MCCB-XT2-XT4

ABB | SACE Tmax XT

Remote Link configurations Regarding the Link functions, the following further parameters are available:
Information Description Default
Link Actor (1÷15) IP address of each actor (from 1 to 15) 0.0.0.0
Configuration parameters of the configurable states:
• selection of actor (actor from 1 to 15) which activates the
Remote Programmable programmable status Actor 1
Status (A÷D) Nobody
• event of the actor that determines change of
programmable status
Configuration parameters of the words:
Remote Status word • selection of actor (actor from 1 to 15) from which the word None 1
(A÷D) status is taken global
• selection of the taken word
Active (Passive diagnosis) or deactivated (No diagnosis) No
Diagnostic
cabled selectivity diagnosis Diagnostic
Diagnostic check 30 s, 1 min, 10 min, 60 min diagnosis frequency intervals 30 seconds
timeout available, if activated
Configuration of hardware selectivity (Only HW) or hardware
Zone Selectivity Type HW only
and logic (Mixed)
Repeat Configuration Interactive mask for selecting selectivity to be sent also to 0x0000
mask the upper levels, even if not active in the programmed device

Remote information Additional information can be accessed via the service connector (via Ekip Connect) or via a system bus
communication:
Information Description
HW and Boot version general module information
Flash CRC status and result Information about the correctness of the SW in the module
Ekip Link status Signals Ethernet cable connection errors
SNTP Server Error Error in communication with SNTP server
SNTP Server Synchronization State of synchronism with SNTP server
Valid with Master IEEE 1588= ON, notifies the presence (Slave or
IEEE 1558 status PTP Master Active) or absence (PTP Master but Passive) of the
higher level master

Remote Link information Regarding the Link functions, the following further parameters are available:
Information Description
Information about the state and inconsistency of HW and logic
Line Congruency detection
selectivity (state and type of selectivity inconsistent)
Remote Programmable Status state (true/false) of remote programmable states A, B, C and D
Remote Status Word value of remote programmable Words A, B, C, D
Logic Zone Selectivity Logic selectivity states (inputs and outputs)

187 | © 2022 ABB | 1SDH002031A1002 - ECN000212994 Internal accessories | 6 - Ekip Link