Page 123 - MCCB-XT2-XT4

ABB | SACE Tmax XT
External electronic accessories

1 - Introduction to the electronic accessories

Operating conditions Ekip Synchrocheck, Ekip Com, Ekip Signalling and Ekip CI function correctly:
• In the presence of auxiliary supply voltage
• With the circuit-breaker in the Racked-in position (if the CB version is withdrawable)
The limitations listed below apply in all the other cases:
Modul / Con- Ekip Synchro- Ekip Com Ekip Signalling Ekip CI
dition check
Output contact:
Module power Synchronization Communication: Output contacts: maintains previous
supply absent contact: open absent open
position
CB in Test (1)(2) Synchronism: not Communication: Inputs and output Inputs and output
position available (4) active contacts: available contact: functioning
CB in Synchronism: not Communication: Inputs and output Output contact:
DISCONNECTED (4) (5) contacts: partial maintains previous
(1)(3) position available partially active available (6) position

(1) the description refers to the module when correctly on and with the CB in the indicated position
(2) in the Test position, the Trip unit is connected to the modules and all information is available on
the display or via external communication
(3) in the Racked-out position, connection and communication between Trip unit and modules is
interrupted. Information is not available/valid
(4) due to voltage not connected to the internal sockets
(5) see System Interface, INFORMATION WITH PROTECTION TRIP UNIT DISCONNECTED section (next
page)
(6) the outputs only function correctly if configured as: input status (of module itself) or non-
communication with Trip unit. For all other configurations, the module forces the Outputs as per
Contact Type parameter (NO, NC).

System Interface Document 1SDH002031A1101.zip, describing how to use the Ekip Com communication modules correctly,
is available in ABB library; the file contains:
Document Description
Guidelines with details about how to put the communication modules
1SDH002031A1101.pdf
into service, with reference to the protocols and supporting documents
Table with the references of all the registers for parameters, controls,
1SDH002031A1101.xlsx
measurements, etc.

The .zip file contains the files for supplementing Ekip Touch in the available communication networks,
with the specific Ekip Com module and an IMPORTANT file with notes on how to use the files:
File (1)(2) Protocol / Ekip Com module
File .gsd and module image for configuring Ekip Com
ABBS0E7F.gsd + EkiDPB.bmp
Profibus DP
Ekip_COM_EtherNetIP_M4_vx_xx.eds File .eds for configuring Ekip Com EtherNet/IP TM
Ekip_COM_DeviceNet_vx_xx.eds File .eds for configuring Ekip Com DeviceNet TM
ABBECxxxx_Ed1.icd File .icd for configuring Ekip Com IEC 61850
ABBECxxxx_Ed2.icd
GSDML-Vx.xx.xml File .xml for configuring Ekip Com Profinet

(1) The files are also valid for the respective Redundant versions.
(2) Check the Firmware version of your module so as to choose the file with the correct configuration.

121 | © 2022 ABB | 1SDH002031A1002 - ECN000212994 External electronic accessories | 1 - Introduction to the electronic accessories